MKS TMC2100 stepper motor driver
Posted: Sat Apr 16, 2016 3:35 am
Is it possible to use these on the control boards supplied with Geeetech printers ?
Geeetech
Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
https://forum.geeetech.com/
MKS TMC2100 stepper motor driver
Page 1 of 1
Re: MKS TMC2100 stepper motor driver
Posted: Sat Apr 16, 2016 1:44 pm
Are they compatible with A4988? If so you can use it on the board I think.
Re: MKS TMC2100 stepper motor driver
Posted: Mon Sep 19, 2016 2:40 pm
They are compatible.
Do I need to adjust any voltage?
According to http://blog.gummibaer-tech.de/tmc2100-s ... olu-a4988/
it is not needed.
Thanks !
Do I need to adjust any voltage?
According to http://blog.gummibaer-tech.de/tmc2100-s ... olu-a4988/
it is not needed.
Thanks !
Re: MKS TMC2100 stepper motor driver
Posted: Wed Sep 21, 2016 9:33 pm
Update: Just replaced 3 of my Drivers.
in spreadCycle Mode they produce a lot of noise when powered with 12 volts.
The StealthChop works perfectly. Just remove all 3 jumpers and dont connect pin conf1-3.
Voltage is adjusted to 0,6V, works just fine.
Nearly noiseless running now.
in spreadCycle Mode they produce a lot of noise when powered with 12 volts.
The StealthChop works perfectly. Just remove all 3 jumpers and dont connect pin conf1-3.
Voltage is adjusted to 0,6V, works just fine.
Nearly noiseless running now.
Re: MKS TMC2100 stepper motor driver
Posted: Thu Sep 22, 2016 10:04 am
Thanks for sharing. 