push the bed out at the end of the printing
Posted: Wed Apr 20, 2016 5:16 pm
hi
can some one know please?
what is the g-code that i need to put to push the bed out ?
i try just g0 y200 but sometimes it dont do that . its depend ehre the bed is,,
so i need the code that will push the bed all the way out no matter where it is now
thank
yossi
can some one know please?
what is the g-code that i need to put to push the bed out ?
i try just g0 y200 but sometimes it dont do that . its depend ehre the bed is,,
so i need the code that will push the bed all the way out no matter where it is now
thank
yossi