Geeetech

Hi, all.
I just got a new toy, the Reprap Prusa I3 DIY 3D printer from ebay.
I'm using Cura, ABS filament and the set the temp at 240, bed at 60. I don't know why the filament not stick to the glass (bed), they just pop up and stick to the nozzle when printing? Thank you very much for any help.

Check this link, it may be helpful to you.
https://www.simplify3d.com/support/prin ... to-the-bed

Toy wrote:Check this link, it may be helpful to you.
https://www.simplify3d.com/support/prin ... to-the-bed

Wow, great information. Thank you so much, Toy.