Page 1 of 1

Sanguinololu LCD

Posted: Tue Jun 07, 2016 6:23 pm
by andy01842
I have a Sanguinololu controller on my riprap printer the Z axis was 50 per cent out of calibration like so many!
I took my life in my hands and reloaded the firm ware with the corrections. The LCD, SD card and display has not worked from that day! read all the posts tried lots of different fixes nothing works. I have connected the LCD to a Arduino uno wrote a simply program and it works great but not from the Sanguinololu controller.
Has anyone ever got one of these to work if so where do I get a copy of the working firmware?
Andy

Re: Sanguinololu LCD

Posted: Wed Jun 08, 2016 11:33 am
by William
Hi,Andy
About the firmware you can download it on our official website.Here is the link:
http://www.geeetech.com/forum/viewtopic ... 20&t=17046
In addition,what caused the LCD, SD card and display didn't work maybe the wrong position of the LCD's and SD CARD's input,you can swap them first,that may work.
Best Wishes
William