Geeetech

Does anyone know where to get a glass bed for the M201. The size is so irregular/big I have looked everywhere? The aluminum bed is far from flat. Is there a more heavy duty aluminum bed out there? That's flat? 12 hours attempting to get the bed printable has left me tired. It's high in the middle. I'm printing a quadcopter that takes up the whole bed, so you can see where its high and low at the beginning of the print.

Regards Joe

Trauma54 wrote:Does anyone know where to get a glass bed for the M201. The size is so irregular/big I have looked everywhere? The aluminum bed is far from flat. Is there a more heavy duty aluminum bed out there? That's flat? 12 hours attempting to get the bed printable has left me tired. It's high in the middle. I'm printing a quadcopter that takes up the whole bed, so you can see where its high and low at the beginning of the print.

Regards Joe

Hello,my friend
You can contact our sales(sales@geeetech.com) to learn more about it.

i remove the alum plate
and put regular glass 5mm !! works great !!!

yossi