First print - Printing calibration problem
Posted: Fri Jul 29, 2016 11:10 pm
Hi,
Thanks to your help, i have finished to work with my Prusa I3 Pro C.
Now, it seams to work. And i begin to print my firsts objects.
To be sure of calibration, i used a file i found on internet, specially to test your printing calibration etc.
http://www.thingiverse.com/thing:13053
Here is the result attached. As you can see i have 2 problems
1) when it begin to print it's 'over printing', which means it goes too much out when it begin, creating a big bullet of plastic. (see details picture below)
2) because of this, it fail to make a complete line at the beginning.
3) in one specific angle (bottom left), you can see it has a discontinuation. When the X axies is moving, i think there is a problem, but it's only doing it on this corner.
Otherwise, it seams OK for the first print.
Do you have any idea how to solve those problem?
Thanks for your help once again
Thanks to your help, i have finished to work with my Prusa I3 Pro C.
Now, it seams to work. And i begin to print my firsts objects.
To be sure of calibration, i used a file i found on internet, specially to test your printing calibration etc.
http://www.thingiverse.com/thing:13053
Here is the result attached. As you can see i have 2 problems
1) when it begin to print it's 'over printing', which means it goes too much out when it begin, creating a big bullet of plastic. (see details picture below)
2) because of this, it fail to make a complete line at the beginning.
3) in one specific angle (bottom left), you can see it has a discontinuation. When the X axies is moving, i think there is a problem, but it's only doing it on this corner.
Otherwise, it seams OK for the first print.
Do you have any idea how to solve those problem?
Thanks for your help once again