Geeetech

Hi.
Will this duel extruder

http://www.geeetech.com/mk8-dual-extruder-p-921.html
Fit this printer on ebay
[Sintron] Ultimate 3D Printer Full Complete Kit for DIY Reprap Prusa i3 + RAMPS 1.4, MK8 Extruder, MK3 Heatbed, and LCD Controller
And will it be any good
Thanks

Richb007 wrote:Hi.
Will this duel extruder

http://www.geeetech.com/mk8-dual-extruder-p-921.html
Fit this printer on ebay
[Sintron] Ultimate 3D Printer Full Complete Kit for DIY Reprap Prusa i3 + RAMPS 1.4, MK8 Extruder, MK3 Heatbed, and LCD Controller
And will it be any good
Thanks

Hi,
Since your printer supports MK8 extruder,i think you can install the dual extruder on it.
But you need to make some modification on your printer's hardware and software like the PSU,the motor driver,the dual extruder holder,the firmware,it will be fantastic if you're experienced.
You can also refer to the upgrades of our Pro B(MK8) to Pro C(dual MK8):
http://www.geeetech.com/forum/viewtopic ... 13&t=17887