Geeetech

Hello,

i just received the already set up printer (Me Creator 2) today and during following the manual (i'm 100% sure that all values in printer settings are correct, checked them 5 times) i can not complete the motor testing part, since the x-axis motor is not stopping at home position but pushing against the y-axis motor making a terrible sound so i have to emergency stop. It is happening in Repetier Host and also with Pronterface. The Y-axis is returning normal to home position. I believe that z-axis is also not going correctly to home position since it is very close to the extruder and i emergency stoped before it would touch it. I refreshed the firmware with arduino version 1.0.1, still same problem. When i reverse the home position for x in firmware from max to min the extruder is driving on the x axis to the left and is then also not stopping and i have to emergency stop. I am very new to this topic and would be happy about any help. I searched already for this problem in the forum, but there was no obvious solution i could find to this.

Hi Guys! I Found what was causing the issue. The Little metal part which is pressing the switch on the x axis to trigger the max signal was not activated by the extruder! You should check if the led is turning on when the extruder is hitting it