Page 1 of 1
3d touch monting
Posted: Thu Feb 02, 2017 11:28 pm
by JonasB
Hi. Am I missing something? Exactly what parts are needed to mount a 3d touch sensor to a mk8 extruder. I have printed the holder but how to attach it to the extruder?? The manual shows an angled plate on the extruder that the holder should attach to but I haven't got that??!!
Re: 3d touch monting
Posted: Sat Feb 04, 2017 6:55 pm
by JonasB
See attached picture. My extruder haven't got the part inside the red rectangle.
Re: 3d touch monting
Posted: Sat Feb 04, 2017 9:58 pm
by wiccan2
Are you able to post a picture of your extruder, it may allow people to help you better.
Re: 3d touch monting
Posted: Mon Mar 20, 2017 4:03 pm
by fragglerok
The holes in the picture are part of the metal carriage that the extruder screws on to
Re: 3d touch monting
Posted: Mon Mar 20, 2017 4:14 pm
by JonasB
Ok. Didn't have that part on my extruder but now I have bought one. Just going to mont it.