Heated Bed upgrade question
Posted: Thu Feb 09, 2017 8:12 am
So I am looking to redo my geeetech prusa i3 dual head printed to a larger frame and was looking to put a 300 by 300 bed on it.
what I would like to do is use this one.
https://folgertech.com/collections/heat ... 0x300-ft-5
However I noticed that it is a 12v 19 amps. and my understanding is that the GT2560 only supports up to a 12 amp heated bed, is there anything I can do to make this work? (Short of using a different board).
what I would like to do is use this one.
https://folgertech.com/collections/heat ... 0x300-ft-5
However I noticed that it is a 12v 19 amps. and my understanding is that the GT2560 only supports up to a 12 amp heated bed, is there anything I can do to make this work? (Short of using a different board).