Geeetech

allo ma carte gt2560 a bruler sur ma gs2pro ?? Jai acheté l'imprimante en octobre 2016. pourquoi a telle bruler ? j'aimerais avoir des détailles et savoir si il y a d'autre personnes a qui cela a arriver
et avoir un retour de garantie aussi

Allo my card gt2560 to burn on my gs2pro ?? I bought the printer in October 2016. why has such burning? I would like to have details and find out if there are other people who have this happen
And have a return of warranty as well

Did you contact the seller?The power cable and the board need to be replaced...

I had the same issue happen to my Prusa I3 Pro B. When printing PLA I had no problems but as soon as I tried to print ABS it looks like it overloaded the circuit. I read there are two solutions...

either desolder the old 4-pin connector and solder wires directly to the board and use XT60 connectors

or

buy a MKS MOSFET - which requires no soldering and bypasses the board altogether.

I chose the former because I'm okay with soldering. (Be warned it is a delicate operation.)