Centered object only prints 1/4 of object
Posted: Mon Mar 20, 2017 9:48 pm
I loaded a small 1 inch diameter test print and centered it on my Geeetech Rostock 301 build area but when it sliced and printed only one corner printed. I moved the object to a different position and the whole object printed. It appears that the software does not know where the printable area is.
Problem solved - it was the firmware update at 1.0.13. Apparently the x and y min are now -85 and the max is +85 - once I set those values I can use the whole print area. User error...
Problem solved - it was the firmware update at 1.0.13. Apparently the x and y min are now -85 and the max is +85 - once I set those values I can use the whole print area. User error...