Geeetech

Hi my probe does not make the printer z axis stop when the probe touch the bed.

when sending m code the probe does not react too. the 3dtouch must be faulty.

what to do ?

glenn_3D wrote:Hi my probe does not make the printer z axis stop when the probe touch the bed.

when sending m code the probe does not react too. the 3dtouch must be faulty.

what to do ?

Hi,you can adjust the screw on the top of the sensor to make it at critical point by the following video:https://www.youtube.com/watch?v=Ix7lXvf ... e=youtu.be.If it still don't work,could you take a video about your actual case as much more detail as possible?It will be more clearer and easier to find the key point.

But it does not respondto th M280 codes at all.

William wrote:

glenn_3D wrote:Hi my probe does not make the printer z axis stop when the probe touch the bed.

when sending m code the probe does not react too. the 3dtouch must be faulty.

what to do ?

Hi,you can adjust the screw on the top of the sensor to make it at critical point by the following video:https://www.youtube.com/watch?v=Ix7lXvf ... e=youtu.be.If it still don't work,could you take a video about your actual case as much more detail as possible?It will be more clearer and easier to find the key point.

Hi,Could you take a video about the detail?

i got it to recieve m messages now. loose connection


anyway now the probe does only probe right once in a while.

it seems like the probe does not always know it was triggered ort it sewnd the message to the gt2650 board to sloly it just keeps going down after in contact with the bed.

what to do ?? soon going to return this product and printer

ok this definatly deserves a zero star rating on ebay. thx for noting