Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
https://forum.geeetech.com/

Prusa i3 z axis bearing on x end carriages

https://forum.geeetech.com/viewtopic.php?t=19400

Page 1 of 1

Prusa i3 z axis bearing on x end carriages

Posted: Thu May 25, 2017 7:02 pm
by Jpk
Hi I am assembling my i3 at the moment and when trying to fit the linear bearings to the x end carriages, I am unable to. The carriages have been drilled for one long bearing mount, but 2 short bearing mounts have been supplied.

Does anyone have the specifications for the long linear bearing mount before I have to drill out the carriage plate

Thanks

John

Re: Prusa i3 z axis bearing on x end carriages

Posted: Fri May 26, 2017 10:27 am
by William
Could you send some pictures about the carriages and 2 short bearing?Maybe you should contact your seller to replace with the long bearing mount.
All times are UTC+08:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited