ME Creator Repair
Posted: Fri Jun 02, 2017 2:50 am
One of the printed parts of my ME Creator has split causing problems with belt rub.
Its unusable as it is but I can get my buddy to print off a replacement part.
I need the STL files to do that. I don't have the design ability to do it myself.... yet
Does anyone have the STL files for the few parts on this unit that I can use to fix it up plz?
The picture highlights the one that is broken, but I would like to do them all with a few mods for better idlers and higher % infill for better strength....
Thanx in advance!
Its unusable as it is but I can get my buddy to print off a replacement part.
I need the STL files to do that. I don't have the design ability to do it myself.... yet
Does anyone have the STL files for the few parts on this unit that I can use to fix it up plz?
The picture highlights the one that is broken, but I would like to do them all with a few mods for better idlers and higher % infill for better strength....
- mc6_2_big.jpg (63.86 KiB) Viewed 6520 times
