Page 1 of 1

moving nozzle height

Posted: Wed Jun 14, 2017 3:42 pm
by josephclc
Hi, I have realised a problem while calibrating the height of the nozzle. I first set the the zero of the nozzle, then I move to another point. When I move back to the first point which I just set zero, the nozzle did not end up in the same position but a lower one. What would be the reasons which cause this happen?

Re: moving nozzle height

Posted: Wed Jun 14, 2017 4:04 pm
by William
Hi,I wanna know which printer are you using?

Re: moving nozzle height

Posted: Wed Jun 14, 2017 4:08 pm
by josephclc
G2S Pro

Re: moving nozzle height

Posted: Wed Jun 14, 2017 4:41 pm
by William
After changing values everytime,you need to store the memory.Here is a calibrate video you can refer to,please take a look:https://www.youtube.com/watch?v=VCa_Bvx ... o1VV2ioejQ.