Page 1 of 1

Hotbed dosn't warm up

Posted: Fri Jun 30, 2017 3:43 pm
by derolf
I have a problem with my board GT2650. :?:
The hotbed is no longer warm. At first, it was only sometimes warm, then no more.
The voltage at the terminals of the board is 0 volts. :o
I still have warranty. What can I do? :(

Re: Hotbed dosn't warm up

Posted: Fri Jun 30, 2017 3:56 pm
by William
It is best to check your hot bed line connection,especially with the board.

Re: Hotbed dosn't warm up

Posted: Sat Jul 01, 2017 11:25 pm
by derolf
Sorry, but there is no Voltage on the board for the hotbed. The line connection to the hotbed is ok.

Re: Hotbed dosn't warm up

Posted: Tue Jul 04, 2017 9:19 am
by William
Now, we can make sure that the board has some problems, you can check your printer referring to the following post:
http://www.geeetech.com/forum/viewtopic ... 19&t=17039