3Dtouch not working properly?
Posted: Sun Jul 30, 2017 5:17 pm
Hello guys,
i've installed the Geeetech 3Dtouch sensor on my Geeetech i3 Pro B.
Everything seems fine with the sensor itselft. My problem is, that the first layer (after measurement of the heatbed G29) is not as i expected.
The gap between nozzle and glass is on the right half OK, but on the left half the nozzle touches the glass. i 've attached a photo.
Why is that?
i've installed the Geeetech 3Dtouch sensor on my Geeetech i3 Pro B.
Everything seems fine with the sensor itselft. My problem is, that the first layer (after measurement of the heatbed G29) is not as i expected.
The gap between nozzle and glass is on the right half OK, but on the left half the nozzle touches the glass. i 've attached a photo.
Why is that?