Geeetech

Posted: **Sun Jan 07, 2018 5:06 am**

I'm not able to get the E180 to heat beyond about 5-15 degrees, even after about 20 minutes. Any advice?

Posted: **Mon Jan 08, 2018 5:56 pm**

I think you can remove it out and clean it then install it to the printer.

Posted: **Wed Mar 28, 2018 2:15 am**

Also, if your contacts have noticeably large lumps of solder on them, remove them with a soldering iron ... otherwise contact is bad and temperature readings will be false.

Posted: **Thu Mar 29, 2018 7:06 pm**

Tipam wrote: Wed Mar 28, 2018 2:15 am Also, if your contacts have noticeably large lumps of solder on them, remove them with a soldering iron ... otherwise contact is bad and temperature readings will be false.

Thanks for your sharing!

Geeetech

E180 Temperature won't Go Above 5-15 Degrees (C)

E180 Temperature won't Go Above 5-15 Degrees (C)

Re: E180 Temperature won't Go Above 5-15 Degrees (C)

Re: E180 Temperature won't Go Above 5-15 Degrees (C)

Re: E180 Temperature won't Go Above 5-15 Degrees (C)