Geeetech

Hello there,

on the SD Card are two GCode Files (cat and dog), which were included with the E180 printer.
The printing out this 2 files has very good quality.

Can you provide the printer setting as e.g. *.ini-file for the slicer, which were used for creating this 2 gcode-files (cat and dog)?
In EasyPrint3D (Ver 1.1.7) are 3 setting tabs, where I can change many settings. There is no documentation of right settings, which the E180 can handle.

Regards,
Andreas

Now I'm back home, tomorrow I will upload this profile

I'm also interested - any update ?

Get the Cura settings here

https://howchoo.com/g/mjbmmgmxymn/using ... 3d-printer

hope this helps :)

No - it doesn´t help!

"The Printer is not connected" - but the printer IS connected. While starting Cura the E180 restarts (ergo: Communication is etablished)
in the how-to there is no information about which type of printer is set.

does anyone has the profile for EasyPrint3d?

keoni wrote: Sun Oct 21, 2018 1:58 pm does anyone has the profile for EasyPrint3d?

For which printer?