Geeetech

I'm having trouble setting up Marlin right for my Wanhao Duplicator i3 v2. About a week ago I had it setup to the point where it was working but only when it was hooked to the computer. Turns out it was my Arduino board so I bought anew one and now I'm not having the problems I was. I loaded the same setup that I did with my other one where it was working fine but whenver it is plugged into the computer or I just turn my printer on it says "KILLED. PRINTER HALTED Please Reset" I'm not quite sure what settings I need to change. I'm also having trouble figuring out how to make the dial move to select prints and what not. I know I have to change something in the "pins.h" file but I have no clue what. I am pretty new to this. I've attached my Marlin Config if anyone can help that would be greatly appreciated.
I'm using a RAMPS 1.4 board, Arduino Mega 2560, Wanhao Duplicator i3 V2 Marlin 1.1.6 and Ardunio v 1.8.3 and this is the display I bought: https://www.amazon.com/gp/product/B01B2 ... UTF8&psc=1

1.It seems the wiring of thermistor install not correct
2.The pin define of thermistor may not correct
3.The type define of thermistor at Marlin may not correct