Page 1 of 1
The z axis does not move the correct distance
Posted: Sat May 26, 2018 12:37 pm
by masahiro
I bought GEEETECH Z steps prusa i3 but move it by mistake even if I move the Z axis 1 mm
Is there someone who knows how to deal with it?
I am translating from Japanese
Re: The z axis does not move the correct distance
Posted: Mon May 28, 2018 12:25 pm
by _kaktus_
Hi.
Are you trying to search the forum, there a lot of similar information on this subject.
For example:
viewtopic.php?f=82&t=61203
Re: The z axis does not move the correct distance
Posted: Mon May 28, 2018 3:52 pm
by Gingko
[quote=masahiro post_id=84320 time=1527309443 user_id=65811]
I bought GEEETECH Z steps prusa i3 but move it by mistake even if I move the Z axis 1 mm
Is there someone who knows how to deal with it?
I am translating from Japanese
[/quote]
In the user manual, there are instructions for changing the direction of each motor.
You can refer to it!