My latest printout.

Post by **_kaktus_** » Sat Jun 09, 2018 12:17 am

For everyone interested, I can present a recently printed item in the form of a rose for Garbrela.

: a close-up view of the rose.; DSC07736.JPG (553.56 KiB) Viewed 11989 times

As you can see, and you can be successful.

I encourage everyone to read this forum because it contains a lot of good information.

It is annoying how some new forum members act.
They don't look for solutions to problems, they duplicate the threads and present their pain...

I wish everyone perseverance and independence in solving problems.
And I encourage you to share your experiences.

kind regards

Post by **Gingko** » Mon Jun 11, 2018 11:55 am

Wow!
That's awesome!

Post by **_kaktus_** » Mon Jun 11, 2018 10:28 pm

My new reset button.

: components of a push button; elementy_przycisku.jpg (409.54 KiB) Viewed 11964 times

: view after installation; widok_po_zamontowaniu.jpg (148.67 KiB) Viewed 11964 times

These pictures do not require any comment.

Post by **_kaktus_** » Thu Jun 28, 2018 2:17 pm

Yesterday the newest cover for my printer was created.
This time it was a cover for the LCD module. The printout lasted almost 6 hours.

Link to the gallery.

Post by **_kaktus_** » Tue Aug 07, 2018 4:40 pm

A new bicycle lamp holder.

The previous holder had cracked from old age.

Post by **_kaktus_** » Wed Aug 15, 2018 9:05 pm

Hi

Life is not a fairy tale.

My printout:

A print design:

Post by **_kaktus_** » Sat Sep 22, 2018 4:01 pm

The next attempt.

Post by **_kaktus_** » Tue Oct 02, 2018 1:36 am

It would be terrible if a guy with a nickname cactus did not print a cactus.

Post by **_kaktus_** » Sun Dec 02, 2018 4:05 pm

This time the attempt to print the stand was successful.

Post by **_kaktus_** » Sat Jul 06, 2019 4:56 pm

.
The wall thickness is 1.2mm. Height 2cm.

Geeetech