Page 1 of 1
Large z-wobble, x-y axis inflation
Posted: Wed Aug 08, 2018 3:48 pm
by k40z
Hi there.
I've a problem with verticals objects.
They are printed with horizontal deformations and appears like a cyclical inflating/misalignment over x and y directions.
I need help.
Thank you.
Re: Large z-wobble, x-y axis inflation
Posted: Wed Aug 08, 2018 4:22 pm
by _kaktus_
Hi
Can you post a photo of your model?
Re: Large z-wobble, x-y axis inflation
Posted: Wed Aug 08, 2018 9:57 pm
by k40z
Files attached.
Thanks for you reply
Re: Large z-wobble, x-y axis inflation
Posted: Thu Aug 09, 2018 12:35 am
by k40z
Thanks for your attention
Re: Large z-wobble, x-y axis inflation
Posted: Thu Dec 27, 2018 5:53 pm
by MrFranke
Hi,
Did you find any solution to solve this Problem? Because I have this printer for some weeks now and have the same issue, but no solution.
Thanks
Re: Large z-wobble, x-y axis inflation
Posted: Thu Dec 27, 2018 6:07 pm
by _kaktus_
Hi.
It looks as if the axis mechanisms still require calibration, and adjustment.
Read the subforum about the A10 and A30 models there is a lot of information about how to adjust the carriages.
Re: Large z-wobble, x-y axis inflation
Posted: Fri Dec 28, 2018 2:18 am
by MrFranke
I have now read almost the entire forum, but found nothing that is helpful.
The whole system is free of play, the reels run reasonable, I only print with 30mm/s, I checked the driver voltage, nothing helps.
I am on the edge of throwing the printer in the trash
Re: Large z-wobble, x-y axis inflation
Posted: Fri Dec 28, 2018 4:15 am
by _kaktus_
HI.
Someone wrote that the wheels of the trolley squash when not in use.
Don't throw away the equipment, treat everything as a test of your nature.