Geeetech

Hi,
I received the WiFi Module last week. Will make first test prints this week, after the new extruder is mounted on our Geeetech i3 C Pro.

Are there some experiences?
Version 1.011 is the latest one?

Regards,
Moritz

Hi


This is a link to the Geeetech repository.
It is the fastest growing place for software and firmware news.

At the moment there are two branches of this software.

The latest v2.x for the new generation of this module.
And version v1.x for the previous version of the module.

How do I check which version of the module I have?

It is easy.

These versions are separated by the date of manufacture. It is hidden in the serial number of each module.

You will find it on a silver sticker on the module and on the packaging.
Start of designation e.g. 1806223DWF... Contains the date of manufacture (2018-06-22).
New batch begin from 21 June e.g.1806213DWFXXXXY.

Good luck.