Page 1 of 1
Conection problem
Posted: Mon Sep 03, 2018 9:54 pm
by Tiefes
What can I do when the printer is maybe conected with the software but I can t controll the printer , it doesn t run the command
Re: Conection problem
Posted: Mon Sep 03, 2018 10:00 pm
by _kaktus_
Hi
I did not understand your question.
So I will ask.
Not sure if communication with the printer is activated
Re: Conection problem
Posted: Tue Sep 04, 2018 6:37 pm
by Gingko
Have you set the baud rate to 250000/256000?
Re: Conection problem
Posted: Thu Sep 06, 2018 9:59 am
by William
Tiefes wrote: Mon Sep 03, 2018 9:54 pm
What can I do when the printer is maybe conected with the software but I can t controll the printer , it doesn t run the command
How is it going on?