Page 1 of 1

A30 and 3DTouch

Posted: Wed Oct 10, 2018 3:30 am
by Kaitokun
Hello,
I got today my A30 and i bought him together with the 3DTouch sensor... but my A30 only have 3 pins on the top and the 3DTouch have 5 pins (3+2).
Is it possible to change the pins on the top from my Printhead ?

Re: A30 and 3DTouch

Posted: Wed Oct 10, 2018 3:39 pm
by apak
Yes, just remove the board, unsolder the 3 pin conector and you´ll see a 5 pin conector for 3dtouch, but there is no FW that soports it yet, so no hurry