Page 1 of 1
Issue with nozzle temp in firmware V1.37.58?
Posted: Sat Dec 22, 2018 11:06 am
by p_rhodan
Hi,
could it be, that the firmware V1.37.58 has an issue to hold the selected nozzle temperature?
If I print a model with maybe 210 degrees nozzle temperature, than it change always between 208 and 212 degrees.
Imthought with the older firmware version was this always stable or only 1 degrees difference.
What are yours experience?
P_rhodan
Re: Issue with nozzle temp in firmware V1.37.58?
Posted: Sun Dec 23, 2018 12:44 am
by Sneakers
I'm having the same issue.. Not sure what to do.
I'd suggest running a
PID Autotune but Smartto doesn't support it.
P.S. Smartto firmware sucks.
Re: Issue with nozzle temp in firmware V1.37.58?
Posted: Sun Dec 23, 2018 1:13 am
by _kaktus_
Sneakers wrote: Sun Dec 23, 2018 12:44 am
....
P.S. Smartto firmware sucks.
Such a nice kitten and she speaks so badly. Shame on you.
Re: Issue with nozzle temp in firmware V1.37.58?
Posted: Sun Dec 30, 2018 1:29 am
by p_rhodan
Any other information? Would this be fixed in the next firmware update?
Re: Issue with nozzle temp in firmware V1.37.58?
Posted: Sat Jan 12, 2019 12:27 am
by _kaktus_
Hello.
As far as I know, the work on improving the firmware is very intensive.
Re: Issue with nozzle temp in firmware V1.37.58?
Posted: Mon Jan 14, 2019 1:24 am
by Lexan
p_rhodan wrote: Sun Dec 30, 2018 1:29 am
Any other information? Would this be fixed in the next firmware update?
yes
Re: Issue with nozzle temp in firmware V1.37.58?
Posted: Wed Jan 30, 2019 8:41 am
by p_rhodan
Very good!
Any release date available? When can we get the new firmware?
Thanx!
Re: Issue with nozzle temp in firmware V1.37.58?
Posted: Tue Mar 12, 2019 6:10 am
by Lexan
you will find it on the geeetech.com page under download
the new upgrader is in the software section