Geeetech

I have the Geeetech I3 ProW
I have connected the 3DWifi box, as the instructions said, I have set up a machine profile, and a material Profile.
I have an android phone of about a year old.
it said printer on line.
1) The original SD card in 3D Wifi does not respond to the app on the phone ,
2) Using the move option on the APP, the printer ignores me completely .
3) The GT_printer, does not have any internet access.
4) When I use the Telstra Wifi (same router) ,I can connect to the server and look at the cloud STL files,anything But the SMALLEST FILES TAKES ABOUT 30 MINUTES. the tiny files take about 30 seconds to splice and upload to 3Dwifi, printer ignores it again.
Can you tell me how to integrate the wifi and the internet (GT_printer and Telstra wifi (same router), in to one stream, so I can access the cloud with my designs and your cloud designs

Regards
Confused and frustrated
Mark Laurence

Hello.


I would like to ask you to describe how the LED lights behave, from the moment the power is switched on.
You can also prepare a short movie.

The 3D Wifi powers up, lights blink as expected, then lights stay on, phone said printer on line, but no action are possible.
1) Can not move extruder head
2) Can home any of the x,y, z
video is in dropbox

https://www.dropbox.com/sh/u9l34npquo8t ... -Stpa?dl=0

Hi.


The film shows that the 3DWiFi module obtained the correct link and the printer is connected.

I will ask you if you have added a printer profile and configured the baud rate

You need to check the baud rate at first.

Yes I have done both
I have uploaded the screen captures of the pages in question.

Dropbox link

https://www.dropbox.com/sh/u9l34npquo8t ... -Stpa?dl=0