Youtube videos for Geeetech A30 + new upcoming printers from Geeetech
Posted: Sun Mar 17, 2019 5:22 am
Hi.
You are invited to watch videos about Geeetech A30 3D printer. Videos will be published according to my publishing schedule. At the moment there are several prepared:
1. Unpacking, comparison to Creality CR-10S PRO and general problems with the printer. I also discuss WHAT NEW PRINTERS is GEEETECH PREPARING.
2. Correcting Y-AXIS offset problem.
3. Upgrading of stepper motor drivers with Trinamic TMC2208.
4. Bed levelling.
None of the videos was sponsored and present only my opinion. More will come if there will be interest, so you are invited to comment under my youtube videos.
https://www.youtube.com/channel/UCIOIhh ... LB0azJmd8w
http://www.rodic.si (may be slow)
You are invited to watch videos about Geeetech A30 3D printer. Videos will be published according to my publishing schedule. At the moment there are several prepared:
1. Unpacking, comparison to Creality CR-10S PRO and general problems with the printer. I also discuss WHAT NEW PRINTERS is GEEETECH PREPARING.
2. Correcting Y-AXIS offset problem.
3. Upgrading of stepper motor drivers with Trinamic TMC2208.
4. Bed levelling.
None of the videos was sponsored and present only my opinion. More will come if there will be interest, so you are invited to comment under my youtube videos.
https://www.youtube.com/channel/UCIOIhh ... LB0azJmd8w
http://www.rodic.si (may be slow)