Geeetech

Hi everyone, I was wondering if in some way it is possible to increase the print volume to be able to print a cover of a Galaxy s10 +
the place is the plan allows it but the g180 stops at 130 and I would like to take advantage of the remaining volume ... can you do from firmware? if yes .... how?
Excuse my horrible English, I am Italian and I do not find people from my country to help me.

--------------------------------------------------------------------------------------------------------------------
LINGUA ORIGINALE
Ciao a tutti, chiedevo se in qualche modo è possibile aumentare il volume di stampa per poter stampare una cover di un Galaxy s10+
il posto c'è il piano lo permette ma la g180 si ferma a 130 e vorrei sfruttare il restante volume... si può fare da firmware? se si.... come?

Hello.


Your English is fine.

If there is no such option in the printer menu, I think you will not avoid this restriction.

You can still try to run a test from Slicer e.g. Repetier -Host.
Try to configure it according to your preferences and then move the mechanism to the extreme position.

Ok the Extreme position is 136mm
Tnx