Page 1 of 1
A10M Overheating problem
Posted: Fri Jun 14, 2019 3:01 am
by ToyaHSW
After the first print, I encountered this error.
I can't control the temperature and go up to 270-280 degrees.
What could be the problem?
Re: A10M Overheating problem
Posted: Fri Jun 14, 2019 9:55 am
by William
Hi, maybe you need to replace the thermistor on the motherboard and measure the resistance between the blue and green lines on the hotbed.
Re: A10M Overheating problem
Posted: Sun Jun 16, 2019 1:41 pm
by SKP
i have the same problem with my a10! it just goes up and overheats! did you figure out why?
Re: A10M Overheating problem
Posted: Sat Jul 06, 2019 1:59 am
by Jarda3d
Try to use some contact spray.
At the first print I was problem with Z axis, where are bad contacts due oxydation