Geeetech

Posted: **Wed Dec 25, 2019 7:41 am**

when plugging then x_m cable into the extruder socket I smelled burnt smoke and the printer stopped working. What should i do? Which piece should I exchange? Help me

Print model: A10T

Posted: **Wed Dec 25, 2019 9:26 am**

Hi, You can check if you can turn on the printer normally,

If it can be opened, what is the situation on the motherboard,

Check if there are signs of burnout.

Use a multimeter to measure the continuity of the wires you connect.

I hope this can help you.

Geeetech

Crash when connecting x_m cable into the socket of the extrusion

Crash when connecting x_m cable into the socket of the extrusion

Re: Crash when connecting x_m cable into the socket of the extrusion