Geeetech

I’m using repetier host and slice with cura
I can print good having my laptop connected. When i print from pc connected with usb it lays a good layer of filament but when I print from Sd card it bearly puts down filament. It puts a super fine line of filament
When I save g code to the sd card it seems like the cura config files and filament setting don’t save.
I tried saving g code to file. Save Gcode to sd card and save gcode in the g code editor and won’t print good at all from sd.

I would like to leave my printer printing without leaving my laptop connected.
I have a geeetech a30m With upgraded extruders gears

So how can I save all my settings to sd card for it to print good ? Or
how to I permanently upload all my settings to my printer ?

Hi,You need to import the cut gcode into the SD card, and it cannot be stored in any folder.