Page 1 of 1
I get weird symbols on the screen and it stops printing
Posted: Wed Apr 01, 2020 8:15 am
by kalizo
hi i need help
I start printing but the screen is put on with these symbols and I don't extrude. It stays moving over one or two millimeters.
Re: I get weird symbols on the screen and it stops printing
Posted: Wed Apr 01, 2020 10:03 am
by William
Hi, you can reconnect the screen cable
Screen interference may occur due to signal interference.
Re: I get weird symbols on the screen and it stops printing
Posted: Fri Aug 07, 2020 1:49 pm
by clifordr
I have been utilizing my Pruse i3 MK3S, and it has worked perfectly for ~3 months. I use OctoPrint on a Pi3B(+? can't recollect), and I have it in a fenced in area in the shed (temperature in shed right now ~3-7°C, moistness is genuinely high, however surely bring down that outside the shed) with both the force flexibly and Raspberry Pi outside the walled in area.
192.168.100.1 192.168.1.1 jpg to pdf