Page 1 of 1
Anyone have Marlin 2.0 working with Auto-Leveling Capability
Posted: Fri Apr 24, 2020 1:11 pm
by Hopsing
I could not get Marlin 1.1.8 to work with my GT2560 V3 board. I loaded Marlin 2.0 Bug-Fix and it runs great. I have not been able to get the auto-touch routine active in the configuration.h file. Hoping someone can post a Marlin 2.0 configuration with the touch sensor working. The probe is works just fine. Thanks in advance.
Re: Anyone have Marlin 2.0 working with Auto-Leveling Capability
Posted: Fri Apr 24, 2020 2:41 pm
by William
Hi，do you mean using 3Dtouch？
Re: Anyone have Marlin 2.0 working with Auto-Leveling Capability
Posted: Fri Apr 24, 2020 10:00 pm
by Hopsing
Yes, I can get the probe to work but the z axis is screwed up. I can't get the z axis to home at the base. I was hoping someone had a good configuration.h file that had solved this problem.
Re: Anyone have Marlin 2.0 working with Auto-Leveling Capability
Posted: Sat Apr 25, 2020 10:30 am
by William
Sorry, we have not used Marlin2.0.