Page 1 of 1
end stop failure
Posted: Tue May 12, 2020 12:40 am
by Ade O
hi help the end stop microswitches for both the x and z axis have both had the metal tang that presses the button when tha carriage comes to home have both broken almost at the same time is there a better switch I can use or another fix anybody knows of
thanks
Ade
Re: end stop failure
Posted: Tue May 12, 2020 11:28 am
by William
Hi,is the limit switch faulty?
or you can provide picture.
- 微信图片_20200512112644.jpg (188.36 KiB) Viewed 7971 times
Re: end stop failure
Posted: Wed May 13, 2020 9:09 am
by Ade O
yes my friend whats happened is the metal tang that sits above the red dot switch has broken at the point where it is attached to the micro switch proper
Re: end stop failure
Posted: Wed May 13, 2020 9:29 am
by Ade O
- microswitch.jpg (111.21 KiB) Viewed 7960 times
Re: end stop failure
Posted: Wed May 13, 2020 9:31 am
by Ade O
on both the z axis and x axis end stop micro switches the whole metal part has come off them both
Re: end stop failure
Posted: Thu May 14, 2020 11:58 am
by William
OK，You can contact the salesperson of the purchase platform to replace it.
Re: end stop failure
Posted: Sun May 17, 2020 1:48 am
by Ade O
ok thanks mate
Re: end stop failure
Posted: Mon May 18, 2020 12:26 pm
by Ade O
thank you the new parts are winging there way to me as we speak
Re: end stop failure
Posted: Mon May 18, 2020 2:03 pm
by William
