3D Bency Print Issues
Posted: Sat Jul 25, 2020 10:12 am
My 3D Benchy has two problems when printed using PLA:
1. When the bow of Benchy prints it looks like it is slightly saggy.
2. The bottom of Benchy is not one piece and eggcrate in nature. You can see all the way through to the top.
What EasyPrintsettings would correct these issues?
1. When the bow of Benchy prints it looks like it is slightly saggy.
2. The bottom of Benchy is not one piece and eggcrate in nature. You can see all the way through to the top.
What EasyPrintsettings would correct these issues?
