Geeetech

Hi,

The instructions for the 3d touch install stop at the part using andruino...

i dont understand if i edit the configuration.h on my printer or upload a new one?

im not even sure how to edit the configuration.h

these instructions kind of explain it but not sure? viewtopic.php?f=13&t=17181

has anyone got a written a detailed guide on how to use andruino to edit the configuration.h?

i dont want to wing it and be in a bigger mess.


in short i guess; how do i do this?

Step1.Open the firmware in Arduino IDE,find the following code in Configuration.h:

Hello, it is not recommended that you change the firmware settings yourself. You can directly download the already set firmware. Such as the link below.
viewtopic.php?f=20&t=17046

Correct, if you don't know how to modify marlin (firmware) download the firmware from Geeetech and install.

Best regards.

ok so i did all this. got it updated tried a few different versions and the 3d touch is not responsive at all.

it starts up the pin goes up and down a few times goes red... then not responsive to any commands.

Sounds a defective probe, it´s strange that simptoms.

Best regards.

William wrote: Thu Sep 10, 2020 3:54 pm Hello, it is not recommended that you change the firmware settings yourself. You can directly download the already set firmware. Such as the link below.
viewtopic.php?f=20&t=17046/Tellpizzahut

This is really amazing. Great information about blog.