A10 Broke please help :'(
Posted: Sat Sep 26, 2020 11:19 pm
My A10 broke when i tried to update the firmware and the cable came unplugged.
There is a constant beeping sound when the printer is powered on.
The LCD has 2 rows of black squares and 2 rows empty
The gt2560 v3 Motherboard has the 3 correct red leds showing but it also has an led above the second extruder port showing, ive not got a clue why.
i have tried to reload the firmwire but i get the avrdude: stk500v2_ReceiveMessage(): timeout error.
I have reflashed the bootloader with an arduino uno and that has said it worked.
I have used the ardunio uno as a programmer with a "success" message but no change.
I have updated the USB drivers and theres no change their either.
Any help would be so very much appreciated.
Thanks in advance!
There is a constant beeping sound when the printer is powered on.
The LCD has 2 rows of black squares and 2 rows empty
- 20200926_161202.jpg (122.96 KiB) Viewed 1894 times
- 20200926_161226.jpg (155.01 KiB) Viewed 1894 times
- 20200926_161219.jpg (228.68 KiB) Viewed 1894 times
i have tried to reload the firmwire but i get the avrdude: stk500v2_ReceiveMessage(): timeout error.
I have reflashed the bootloader with an arduino uno and that has said it worked.
I have used the ardunio uno as a programmer with a "success" message but no change.
I have updated the USB drivers and theres no change their either.
Any help would be so very much appreciated.
Thanks in advance!