Massive stringing on A10T - Part 2
Posted: Sun Nov 08, 2020 9:33 pm
Hi,
Still struggling with stringing and which doesn't seems to go away. Tried different settings (using Cura) and even changed the whole extruder part.
Can anyone relate and share their Cura setting for A10T so I can try? Also, I mainly using eSun PLA+ but I tried with other filaments and results are the same.
Attached image with different settings with heat tower. As you can see, all of the attempts are bad.
Still struggling with stringing and which doesn't seems to go away. Tried different settings (using Cura) and even changed the whole extruder part.
Can anyone relate and share their Cura setting for A10T so I can try? Also, I mainly using eSun PLA+ but I tried with other filaments and results are the same.
Attached image with different settings with heat tower. As you can see, all of the attempts are bad.
- IMG_20201108_152151.jpg (162.58 KiB) Viewed 11122 times