I'm struggeling for some days now but cant seem to fix this problem
My printer is not extracting enoug plastic bij printing file's
The Hot end is all clean becaus its a new one.
when i changing filament en and when he push the filament back in there the PLA come's out the hot end without a problem,
so it tells me it most be a setting right?
But when i start printing my file,
i notice the filament is not getting pushed in correct or the my settings are still wrong
but i cant seem to see where the problem come's from or how to fix it
The flow is 130% and printing speed is set on low.
*Sorry Dont mind my bad English and if you need more information please let me know
Here below my settings Hope you can help me.
-Lars