Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
https://forum.geeetech.com/

Hemera mount??

https://forum.geeetech.com/viewtopic.php?t=72274

Page 1 of 1

Hemera mount??

Posted: Fri Feb 05, 2021 1:48 pm
by Benfish65
Hello everyone! Has anyone here tried to mount the Hemera to your MeCreator2? It looks as if it would just fit into the bracket above the linear rods.

Does this look doable? Has anyone tried it? Any comments about trying this?

I’m looking for lots of feedback here. Please comment away!

Re: Hemera mount??

Posted: Fri Aug 06, 2021 3:54 pm
by Einomoen554
Here's my first version of the E3D Hermes mount for the Ender 3. I might do some small teaks. Instead of the stock fan, I use a 40mm blower fan (same as the CR-10S Pro) as i feel it does a better job. It is secured to the fan with some super glue or hot glue. mount prints without supports, the blower duct might need just a little support on the curve from the build plate only.

MyBalanceNow
All times are UTC+08:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited