Nowhere to install TMC2208 on A20T motherboard?
Posted: Fri Aug 06, 2021 6:24 am
Fellow printers,
I was going to upgrade the three extruders with TMC2208 drivers, but there doesn’t seem to be anywhere to plug in the chips on the board. There seem to be 6 small soldered chips where I would expect the driver chips to go. I marked the chips with a red arrow and dots on the picture below, but I’m not sure the picture attached correctly. The A20T is very new (like a month old). Do the new boards not allow adding TMC2208 drivers? Any advice appreciated!
I was going to upgrade the three extruders with TMC2208 drivers, but there doesn’t seem to be anywhere to plug in the chips on the board. There seem to be 6 small soldered chips where I would expect the driver chips to go. I marked the chips with a red arrow and dots on the picture below, but I’m not sure the picture attached correctly. The A20T is very new (like a month old). Do the new boards not allow adding TMC2208 drivers? Any advice appreciated!
- 6FC0C896-CB1B-488E-AD79-FB5CE27BE8B6.jpeg (812.12 KiB) Viewed 3174 times