Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
https://forum.geeetech.com/

X and Z axes crashing

https://forum.geeetech.com/viewtopic.php?t=73629

Page 1 of 1

X and Z axes crashing

Posted: Fri Oct 22, 2021 10:38 pm
by Orochimaru
On my A10M with V4 MB, the X and Z axes are impacting the gantry at the upper limit of their travel (e.g. 220mm X, 260mm Z). Within the last 5mm of travel, the hotend impacts the frame and the motor/belt grinds. Firmware is V1.1.8-V2.0. I've calibrated steps for all axes.
https://speedtest.vet/ https://vidmate.bid/
Any insight or advice would be appreciated.
All times are UTC+08:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited