Geeetech i3 Pro W - Extruder going wrong way
Posted: Mon Jan 31, 2022 6:57 pm
Hi guys,
At a loss on why my extruder is pushing the filament out instead of 'sucking' it in.
Flashed the firmware and set
https://nox.tips/ https://xender.vip/
#DEFINE INVERT_E0_DIR true
#DEFINE INVERT_E0_DIR false
I also set all extruders to true/false
Swapped the plug around
Tried different printing software
Does anyone else have any other ideas?
All of those methods above result in my extruder pushing the filament out.
At a loss on why my extruder is pushing the filament out instead of 'sucking' it in.
Flashed the firmware and set
https://nox.tips/ https://xender.vip/
#DEFINE INVERT_E0_DIR true
#DEFINE INVERT_E0_DIR false
I also set all extruders to true/false
Swapped the plug around
Tried different printing software
Does anyone else have any other ideas?
All of those methods above result in my extruder pushing the filament out.