A20M hotend temperature too high ... 345 deg. celsius
Posted: Sat Jul 30, 2022 1:48 am
hello.
big problem: during printing an object suddenly the hotend increases the temperature over the printing temperature (220deg.C) up to 345 degrees celsius.
the two heater keeps always active and are permanently heating, also after stop of printing.
i'm afraided a burning printer...
after stop of printing and restarting the printer the hotend temperature are increasing althought without starting the print.
initialize eeprom and restore settings not succussfully.
is this issue known?
is the board defect?
or other suggestions about this behavior?
greetings
big problem: during printing an object suddenly the hotend increases the temperature over the printing temperature (220deg.C) up to 345 degrees celsius.
the two heater keeps always active and are permanently heating, also after stop of printing.
i'm afraided a burning printer...
after stop of printing and restarting the printer the hotend temperature are increasing althought without starting the print.
initialize eeprom and restore settings not succussfully.
is this issue known?
is the board defect?
or other suggestions about this behavior?
greetings