Geeetech

Does the gen 6 hardware only support marlin firmware?

Do you have any idea what could be wrong?
Here is my firmware settings: http://pastebin.com/KcXjgHfF

I am running a prusa mendel I2, i am running marlin firmware, http://www.geeetech.com/generation-6-el ... p-677.html this is my printboard

I am using a prusa mendel, using marlin firmware, this is my board: http://www.geeetech.com/generation-6-el ... p-677.html

I just updated and tried again and the same thing occurred

I dont use the hot bed, I am only heating the extruder

I am heating the extruder

By using repetier on the computer

I have another problem with my printer, when i tell the printer to heat to a specific temperature it gets to the temperature, then it disconnects.
Does anyone have any ideas?

THanks for your help, i fixed the problem, there was a problem with my arduino software