Geeetech

Looks like updating from to 1.6.0 fixed the problem :)

Do you know how to print the first layer in higher resolution? When I'm trying to print the first layer with width of 0.3 instead 0.6 as recommended the layer doesn't stick well.

I'm printing pla when I try to print small stuff it looks like ...

Yes they are

In the slicer preview I see the full complete model

Hello,

My prints are kind of OK but in the last layer the printer finishes printing before completing printing the whole layer
as you can see in the photos below
My printer is i3 Pro B and I'm using the slicer configuration as in the instructions
How to solve this problem?

Thanks.

2016-02-07 18 ...

I'm looking for good slicer settings for i3 PRO B with nozzle diameter of 0.3mm

so far I'm not able to get good prints

Thank you!

ok so after playing with slicer's settings and set the extruder's temp to 210C now the result is much better!
but now something is weird with the second layer, the seconded layer is messed up time after time

2015-09-15 19.48.02.jpg
2015-09-15 18.23.55.jpg
2015-09-15 18.22.04.jpg
2015-09-11 ...

I measured the z axis travel and it moved exactly 10mm

I use pla with bed: 70C and nozzle: 180

If you use the same printer can you please share the settings of the printer (control) and the settings of slicer?

I've updated the firmware and I think it messed up printers settings.

I will try to play with the Z step settings and update

1.jpg

This the first layer, as you can see the extruder is a bit far from the bed this is on purpose because otherwise at the upper layers the extruder is so close to the printed model that it actually moving the model on the bed.

2.jpg

3.jpg


last layer, as you can see at the last layer ...

I'm using the recommended settings

http://www.geeetech.com/forum/viewtopic ... 21&t=16379