Ok, turns out there was something wrong with the firmware. This is weird because I had loaded it from Geeetech wiki.
Now the problem is fixed with the firmware Marlin 1.0.3 dev loaded from: http://reprap.org/wiki/Delta_Rostock_mini_G2s#Bed_and_Endstop_Adjustment
However, now I'm facing another ...
Search found 3 matches
- Mon May 16, 2016 1:25 am
- Forum: Products FAQ
- Topic: Rostock mini g2s auto-leveling issue
- Replies: 4
- Views: 6586
- Sat May 14, 2016 8:33 pm
- Forum: Products FAQ
- Topic: Rostock mini g2s auto-leveling issue
- Replies: 4
- Views: 6586
Re: Rostock mini g2s auto-leveling issue
correction from my initial post, after all probing points are saved, the printhead only lifts 5mm instead of 50mm. When I look up my Marlin Firmware configuration.h in Arduino, I see that it should raise 50mm after all probing points are done. 5mm is how it should raise in between each probing ...
- Sat May 14, 2016 11:11 am
- Forum: Products FAQ
- Topic: Rostock mini g2s auto-leveling issue
- Replies: 4
- Views: 6586
Rostock mini g2s auto-leveling issue
Hi!
I need help :), I've been troubleshooting for a while but I'm really stuck and can't make the auto-leveling work as it should.
I did everything as described in the instruction guide. After homing the printer with G28 code and sending G29 code, my printhead will get all the probing points as ...
I need help :), I've been troubleshooting for a while but I'm really stuck and can't make the auto-leveling work as it should.
I did everything as described in the instruction guide. After homing the printer with G28 code and sending G29 code, my printhead will get all the probing points as ...